Preview Questions Carpenter | Role Specific Skill

Question 1: How should ladders be inspected and used according to OSHA standards on a job site?

Which action should you take?

Choose only one option

Ladders should be replaced every 5 years regardless of condition

Ladders can be used without inspection as long as they seem stable

Ladders must be inspected before each use for any damage, and workers should follow proper ladder safety techniques, including maintaining three points of contact

Ladders only need to be inspected if they appear damaged or after a fall

Question 2: What is the correct method for measuring and cutting a compound miter joint for a frame?

Which action should you take?

Choose only one option

Use a coping saw for intricate corners

Use a table saw with a crosscut sled

Use a miter saw with the angle set to the precise cut

Measure and cut each piece individually at 90 degrees

Question 3: What is the required procedure when working near overhead electrical lines on a construction site?

Which action should you take?

Choose only one option

Maintain a minimum distance of 10 feet from overhead electrical lines and use insulated tools

Use uninsulated tools without checking the proximity to electrical lines

Work as close to electrical lines as possible, assuming the lines are inactive

Rely on temporary markers to mark safe distances, without verifying electrical line locations

Question 4: What is the primary purpose of a fall arrest system on a construction site?

Which action should you take?

Choose only one option

To stop a fall once it occurs

To cushion the impact of a fall

To prevent a fall from happening

To slow down the rate of a fall

Question 5: How do you ensure accurate cuts for "angled ceilings" when measuring and cutting drywall for a sloped ceiling?

Which action should you take?

Choose only one option

Use a level and tape measure to measure the exact slope, then cut drywall at the appropriate angle

Angle measurements are irrelevant as long as the drywall covers the space

Measure the height of the ceiling and cut drywall to a standard length

Drywall for angled ceilings does not require precise measurements, just cutting the sheets

Question 6: What is the key safety requirement for operating a "power nailer" during carpentry work?

Which action should you take?

Choose only one option

Only hand protection is needed when using a power nailer

Power nailers do not require safety checks as they are simple tools

Power nailers can be used without any safety training or preparation

Operators must ensure they are using the correct trigger mechanism, wearing eye and hearing protection, and maintaining proper hand placement