Preview Questions Painter | Role Specific Skill

Question 1: What is the effect of over-thinning paint when mixing for spray applications?

Which action should you take?

Choose only one option

Increases adhesion to the surface

Increases the drying time

Reduces the paint's coverage and can lead to drips

Decreases the gloss level

Question 2: What is the most common reason for paint blistering during application?

Which action should you take?

Choose only one option

Too thick a coat applied without proper drying time in between

Insufficient mixing of the paint and thinner

High humidity and condensation on the surface

Application over an unprepared or contaminated surface

Question 3: Which of the following is the most effective method to prepare a concrete surface before painting?

Which action should you take?

Choose only one option

Applying a chemical etching solution

Sanding the surface with fine-grit sandpaper

Scraping the surface manually with a wire brush

Grinding or shot blasting to remove laitance and create a rough profile

Question 4: What is the most effective technique for painting metal surfaces exposed to high moisture environments?

Which action should you take?

Choose only one option

Use oil-based paint without priming to minimize preparation

Apply a direct coat of enamel over the unprimed surface to save time

Use a rust-resistant primer followed by an enamel finish coat applied with a brush or roller

Spray paint the metal surface with a water-based paint for flexibility

Question 5: What is the minimum required PPE (Personal Protective Equipment) for a painter applying epoxy or polyurethane coatings?

Which action should you take?

Choose only one option

Gloves, goggles, and a protective suit

Gloves, goggles, and a respirator

Gloves, goggles, and hearing protection

Gloves, goggles, and a dust mask

Question 6: What technique should be used when spraying paint on a large exterior surface to minimize overspray and ensure even coverage?

Which action should you take?

Choose only one option

Spray directly up and down over small sections at a time

Spray in one long vertical pass to avoid uneven coverage

Use a wide-angle nozzle and hold the sprayer close to the surface for maximum coverage

Maintain a consistent distance and motion while spraying, using a back-and-forth pattern